Hill Assist and ABS Lights ON (2024)

FAQs

Why is my ABS and StabiliTrak light on? ›

If the brake system is malfunctioning, the traction control light might come on as a result. The light for your ABS might also come on if the brake fluid is low. Your car likely has sensors in those tanks in order to detect when fluids are low, which could be dangerous.

If you see a warning light on your instrument panel depicting a car on a slope, it may be a sign that your Hill Start Assist system is malfunctioning.

If the TCS and the ABS warning lights both come on, along with the red main brake warning light, you should not drive the car until the problem has been fixed. Your entire braking system is affected, and may not be able to stop your vehicle when you need it to. Have your vehicle towed to a repair shop.

The four common reasons that typically cause this light to turn on include a malfunctioning ABS module, low levels in the fluid reservoir, broken wheel speed sensors, or the system is turned off. Your ABS actually shares some important components with another system in your vehicle: your traction control system.

Press the gas pedal 3 times in quick succession. Then, turn your engine on all the way and let it run for a minute. The TCS and ABS lights should reset and go away if there isn't any underlying problem with your traction control system.

Despite being such a complicated system, Stabilitrak repairs are surprisingly affordable. A typical Stabilitrak repair costs between $80-$200. That's not bad for a car repair, especially considering how complex these systems can be.

Hill Start Assist serves to stop your vehicle from rolling back while on a hill by automatically operating the brake system for about 3 seconds, even if you release your foot from the brake pedal.

THE TECHNOLOGY BEHIND IT. Sensors in the vehicle are used to detect when a vehicle is on an incline. The hill start assist maintains the brake pressure for a set period of time as you switch from the brakes to the gas pedal. Once you press the accelerator, it releases the brake.

If you see a warning light, come to AutoZone.

Fix Finder reads information from the Check Engine, ABS, and maintenance lights. The test often takes less than a minute once the reader is plugged in. Find the closest store to you.

In general, you can still continue driving even if your car's ABS light is on. This is because your car's brakes still function as usual and can still slow your vehicle down. However, your car's tires are at risk of getting locked under heavy braking and that limits your maneuverability in emergencies.

How do I reset my ABS sensor? ›

Resetting the ABS light.

Disconnect the positive cable from your car battery, then let the electrical system's residual power drain by activating the headlight switch. This method can sometimes reset the ABS warning light. Or, use an OBD-II scanner to reset the ABS light.

Yes, in a somewhat indirect way. As we've mentioned, your car's ABS light can be triggered by low brake fluid. Worn brake pads deplete your brake fluid. By doing this, they can trigger your car's ABS light.

Check your brake fluid: low brake fluid can sometimes trigger the ABS light. Check your brake fluid level and, if it's low, top it up to the correct level marked on the side of the reservoir. Perform a system reset: sometimes, the ABS light can be triggered by a temporary issue or an error in the system.

Sometimes the ABS warning light may illuminate even when your brakes work fine. This often means that the hardware that makes up your braking system is working well. The problem may lie with the sensors that activate the antilock braking system.

However, the StabiliTrak warning light may also signal potential damage to vehicle components that allow the system to work effectively. Driving with StabiliTrak off is generally safe if you recognize that you won't have its assistance during a potential skid or slide.

The average cost for an ABS Control Module Replacement is between $980 and $1,038. Labor costs are estimated between $107 and $135 while parts are priced between $873 and $903. This range does not include taxes and fees, and does not factor in your unique location. Related repairs may also be needed.

The code points to an issue with the Knock sensor on the car. This will also bring on the traction control light, the system is turned off because of the check engine light coming on. In most cases, you will have to replace the knock sensor to resolve the problem. The other should clear once that is done.

Two Different Lights, Two Different Meanings

Most commonly, this light is triggered by low brake fluid or an engaged parking brake. However, on some vehicles, it can simply indicate a problem elsewhere in the system and can be illuminated immediately if there is an ABS fault.